Rear hubs test fitted

Today I test fitted the two front hubs from the XR2 that are used on the rear of the Mojo.

The hub is turned upside down and attached to the lower wishbone bolt with a pair of strengthening spacer brackets. (Shown in pics 2, 3 and at the bottom of 4.)
The lower ball joint, (now at the top as the hub is inverted,) is secured onto the upper wishbone with two nuts and bolts. (Top of photo 4.)
Photo 4 also shows that the steering arm would have got in the way if not grinded off.

Everything will come back off again for a clean up, but this was a very successful test fitting of both rear hubs.